Ford Sierra Manual

Auxiliary shaft - removal, inspection and refitting
SOHC engines / Auxiliary shaft - removal, inspection and refitting


Note: A new gasket should be used when refitting the auxiliary shaft cover (see text).

Removal
1 Remove the timing belt and the auxiliary shaft sprocket.

2 Remove the distributor.

3 Remove the mechanical fuel pump and operating pushrod (where applicable).

4 Unscrew the three securing bolts and remove the auxiliary shaft cover (see illustration).

25.4 Unscrew the auxiliary shaft cover securing bolts and remove the cover
25.4 Unscrew the auxiliary shaft cover securing bolts and remove the cover

5 Unscrew the cross-head screws, using an impact screwdriver if necessary, remove the thrustplate and withdraw the auxiliary shaft from the cylinder block (see illustrations).

25.5a Unscrew the auxiliary shaft thrustplate securing screws and remove the
25.5a Unscrew the auxiliary shaft thrustplate securing screws and remove the thrustplate

25.5b Withdraw the auxiliary shaft
25.5b Withdraw the auxiliary shaft

6 Cut the cover gasket along the top of the crankshaft front oil seal housing and scrape off the gasket.

Inspection
7 Examine the shaft for wear and damage, and renew it if necessary.

8 If desired, the oil seal in the cover can be renewed as follows.

9 Support the cover on blocks of wood and drive out the old oil seal. Drive the new seal into place using a suitable metal tube or socket (see illustrations).

25.9a Driving out the auxiliary shaft cover oil seal
25.9a Driving out the auxiliary shaft cover oil seal

25.9b Using a socket to fit a new auxiliary shaft cover oil seal
25.9b Using a socket to fit a new auxiliary shaft cover oil seal

The sealing lip
must face towards the cylinder block. Smear the sealing lip with clean engine oil before installation.

Refitting
10 Commence refitting by lubricating the auxiliary shaft journals with clean engine oil, then insert the shaft into the cylinder block.

11 Locate the thrustplate in the shaft groove, then insert the crosshead screws and tighten them with an impact screwdriver.

12 Using a dial test indicator (if available), or feeler blades, check that the auxiliary shaft endfloat is within the limits given in the Specifications. If not, renew the thrustplate and re-check. If this does not bring the endfloat within limits, the auxiliary shaft must be renewed.

13 Cut out the relevant section of a new gasket, and locate it on the cylinder block, then refit the auxiliary shaft cover and tighten the securing bolts.

14 Where applicable, refit the fuel pump.

15 Refit the distributor.

16 Refit the auxiliary shaft sprocket and the timing belt.


© 2018 www.fsierra.ru. All Rights Reserved.