Ford Sierra Manual

Centre console - removal and refitting
Bodywork and fittings / Centre console - removal and refitting


Models up to 1990
Full length console
1 Where applicable, prise the electric window switches from the front upper console panel and disconnect the wiring.

2 Remove the three securing screws from the front upper console panel, then withdraw the panel over the gear selector lever, at the same time releasing the rubber gaiter where applicable.

3 On high specification models, where applicable prise the electric window switches from the rear upper console panel and disconnect the wiring. Remove the five securing screws and withdraw the rear upper console panel (see illustrations).

44.3a Removing a rear upper console panel front retaining screw - high
44.3a Removing a rear upper console panel front retaining screw - high specification model

44.3b Rear upper console panel rear retaining screws (arrowed)
44.3b Rear upper console panel rear retaining screws (arrowed)

4 On low specification models, remove the two securing screws and release the single rear clip, then withdraw the rear upper console panel.

5 Where applicable, remove the two screws securing the lower console centre bracket to the transmission tunnel, and remove the bracket.

6 Remove the six screws securing the lower console panel, and withdraw the panel (see illustrations).

44.6a Removing a lower console panel front securing screw . . .
44.6a Removing a lower console panel front securing screw . . .

44.6b . . . centre securing screw . . .
44.6b . . . centre securing screw . . .

44.6c . . . and rear securing screw
44.6c . . . and rear securing screw

7 Refitting is a reversal of removal.

Short console
8 Prise out the blanking plug, and remove the rear console securing screw.

9 On automatic transmission models, lift out the console tray mat and remove the front two console securing screws.

10 On manual gearbox models, prise out the blanking plugs and remove the front two console securing screws.

11 Withdraw the console over the gear selector lever, at the same time releasing the rubber gaiter where applicable.

Models from 1990
12 Remove the switch assembly (after disconnecting the battery negative lead), or remove the blanking plate from the gear lever surround, as applicable.

13 Remove the securing screw from the gear lever surround, and withdraw the gear lever surround from the console by releasing the two securing clips.

14 Remove the seven console securing screws (see illustration).

44.14 Centre console components - models from 1990
44.14 Centre console components - models from 1990

A Screw
B Screw cover
C Gear lever surround
D Blanking plate
E Centre console

15 Chock the rear wheels, then release the handbrake lever.

16 Jack up the vehicle and support it on axle stands (see Jacking and Vehicle Support).

Disconnect the handbrake equaliser from the linkage on the underbody.

17 Raise the handbrake lever fully, and lift the console over the handbrake lever.

18 Refitting is a reversal of removal, but on completion, check the handbrake/cable adjustment.


2018 www.fsierra.ru. All Rights Reserved.