Ford Sierra Manual

Sunroof - removal, refitting and adjustment
Bodywork and fittings / Sunroof - removal, refitting and adjustment


Glass panel - removal and refitting
1 Open the sunblind and remove the three screws and clips shown (see illustration) then slide the lower frame rearwards into the roof.

39.1 Sunroof lower frame-to-glass panel securing screws and clips (arrowed)
39.1 Sunroof lower frame-to-glass panel securing screws and clips (arrowed) Tighten screws in the order shown when refitting

2 Remove the six screws securing the glass panel to the sliding gear (see illustration) then push the glass panel upwards and remove it from outside of the vehicle, taking care not to damage the paintwork.

39.2 Sunroof glass panel-to-sliding gear securing screws (one side shown for
39.2 Sunroof glass panel-to-sliding gear securing screws (one side shown for clarity)

3 Commence refitting by securing the glass panel to the sliding gear with the six screws.

4 Adjust the sunroof as described in paragraphs 10 and 12 to 14 inclusive, but note that there is no need to open and close the roof before checking adjustment.

5 Refit the three clips to the glass panel, then pull the lower frame forwards and secure it to the glass panel with the three screws. Tighten the screws in the order shown.

Complete assembly - removal and refitting
6 Fully open the sliding roof panel, then remove the screw securing the roof operating handle and detach the handle.

7 Remove the four screws on each side and the two screws at the front securing the sliding roof assembly to the roof tray.

8 Lift the front rail and carefully withdraw the assembly forwards from the roof tray, taking care not to damage the paintwork.

9 Refitting is a reversal of removal, but on completion, adjust the sunroof as described in paragraph 10 onwards, and if necessary adjust the position of the roof operating handle so that with the roof in its closed position, the handle can fold into its recess.

Adjustment
10 Fully open and close the sliding roof, then check that the front edge of the glass panel is flush with, or a maximum of 2.0 mm (0.08 in) below the adjacent roof panel. The rear edge of the glass panel should be flush with, or a maximum of 2.0 mm (0.08 in) above the adjacent roof panel.

11 If adjustment is necessary, remove the three screws securing the glass panel to the lower frame, then slide the lower frame rearwards into the roof.

12 To adjust the front edge of the glass panel, loosen the front and centre screws securing the glass panel to the sliding gear.

13 To adjust the rear edge of the glass panel, loosen the rear and centre screws securing the glass panel to the sliding gear (see illustration 39.1).

14 On completion of adjustment, tighten the glass panel-to-sliding gear securing screws.

15 Pull the lower frame forwards and secure it to the glass panel with the three screws.

Tighten the screws in the order shown.


© 2018 www.fsierra.ru. All Rights Reserved.