Ford Sierra Manual

Tie-rod end - removal and refitting
Suspension and steering / Tie-rod end - removal and refitting


Note: A balljoint separator tool will be required for this operation.

Removal
1 Loosen the relevant front roadwheel nuts, apply the handbrake, jack up the front of the vehicle and support on axle stands.

2 Remove the roadwheel. On P100 models mark the position of the roadwheel in relation to one of the wheel studs before removal.

3 Make alignment marks on the tie-rod and tie-rod end, then loosen the locknut by a quarter of a turn.

4 Extract the split pin and unscrew the castellated nut (see illustration).

33.4 Extracting the split pin from the tierod balljoint castellated nut
33.4 Extracting the split pin from the tierod balljoint castellated nut

5 Using a balljoint separator tool, release the tie-rod end from the hub carrier (see illustration).

33.5 Using a balljoint separator tool to release the tie-rod end from the hub
33.5 Using a balljoint separator tool to release the tie-rod end from the hub carrier

6 Unscrew the tie-rod end from the tie-rod, noting the number of turns necessary to remove it.

Refitting
7 Refitting is a reversal of removal, bearing in mind the following points.

8 Screw the tie-rod end onto the tie-rod the number of turns noted during removal.

9 Tighten the nuts to the specified torque, and fit a new split pin to the castellated nut.

10 On P100 models, align the previously made marks on the roadwheel and wheel stud.

11 On completion, check and if necessary adjust the front wheel alignment.


© 2018 www.fsierra.ru. All Rights Reserved.