Ford Sierra Manual

Front disc caliper - removal, overhaul and refitting
Braking system / Front disc caliper - removal, overhaul and refitting


Caution: Refer to the precautions in Section 1.

Removal
1 Apply the handbrake, loosen the relevant roadwheel nuts, then jack up the front of the vehicle and support on axle stands. (see УJacking and Vehicle SupportФ). Remove the roadwheel. On P100 models, mark the position of the roadwheel in relation to one of the wheel studs before removal.

2 Remove the brake fluid reservoir cap and secure a piece of polythene over the filler neck with a rubber band, or by refitting the cap. This will reduce the loss of fluid during the following procedure.

3 Disconnect the flexible fluid hose from the rigid brake pipe under the wing of the vehicle, or alternatively unscrew the flexible hose from the union on the caliper. Take care not to twist the hose, and plug the open ends to prevent fluid loss and dirt ingress.

4 Remove the disc pads.

5 On models fitted with Girling calipers (1.3 and early 1.6 litre models) (see illustration),

6.5 Exploded view of Girling front disc caliper
6.5 Exploded view of Girling front disc caliper

A Caliper
B Guide pin and dust boot C Piston seal
D Piston
E Dust-excluding seal
F Disc pads
G Caliper carrier bracket

unscrew and remove the bolt from the lower caliper guide pin, while holding the pin stationary with a spanner, then remove the caliper.

6 On models fitted with Teves calipers (later 1.6, 1.8 and 2.0 litre models) (see illustration), remove the caliper from the vehicle.

6.6 Exploded view of Teves front disc caliper
6.6 Exploded view of Teves front disc caliper

A Guide bolts
B Caliper carrier bracket C Caliper retaining clip D Disc pads
E Dust-excluding seal
F Piston seal
G Piston
H Caliper

7 If required, the caliper carrier bracket can be unbolted and removed from the hub carrier.

Overhaul
8 Brush away all external dirt and dust, but take care not to inhale any dust as it may be injurious to health.

9 Pull the dust-excluding rubber seal from the end of the piston.

10 Apply air pressure to the fluid inlet union, and eject the piston. Only low air pressure is required for this, such as is produced by a foot-operated tyre pump. Position a thin piece of wood between the piston and caliper body to prevent damage to the end face of the piston in the event of its being ejected suddenly.

11 Using a suitable pointed instrument, prise the piston seal from the groove in the cylinder bore. Take care not to scratch the surface of the bore.

12 Clean the piston and caliper body with methylated spirit and allow to dry. Examine the surfaces of the piston and cylinder bore for wear, damage and corrosion. If the piston surface alone is unserviceable, a new piston must be obtained, along with seals. If the cylinder bore is unserviceable, the complete caliper must be renewed. The seals must be renewed regardless of the condition of the other components.

13 Coat the piston and seals with clean brake fluid, then manipulate the piston seal into the groove in the cylinder bore.

14 Push the piston squarely into its bore.

15 Fit the dust-excluding rubber seal between the piston and caliper, then depress the piston fully.

Refitting
16 Refit the caliper and where applicable the carrier bracket by reversing the removal operations. Tighten the mounting bolts to the specified torque.

17 On P100 models, when refitting the roadwheel align the previously made marks on the roadwheel and wheel stud.

18 On completion, bleed the front brake circuit.


© 2018 www.fsierra.ru. All Rights Reserved.