Ford Sierra Manual

Radiator - removal and refitting
Cooling, heating and air conditioning systems / Radiator - removal and refitting


Removal
1 Disconnect the battery negative lead.

2 Drain the cooling system.

3 If not already done, disconnect the bottom hose from the radiator.

4 Disconnect the top hose and the expansion tank hose from the radiator.

5 On automatic transmission models, place a suitable container beneath the fluid cooler pipe connections at the radiator. Unscrew the union and plug the upper pipe, then repeat the procedure on the lower pipe.

6 Apply the handbrake, jack up the front of the vehicle and support on axle stands (see УJacking and Vehicle SupportФ).

7 To improve access, remove the cooling fan shroud as follows, according to model.

8 On SOHC models, remove the four retaining clips and unscrew the two retaining screws, then withdraw the upper section of the fan shroud. Unclip and remove the lower section of the shroud.

9 On CVH and DOHC models, unclip the wiring connector from the fan motor(s) then unscrew the retaining nuts and washers, and withdraw the fan shroud(s) and cooling fan assembly(s) (see illustration).

5.9 Unscrew the fan shroud/radiator retaining nuts
5.9 Unscrew the fan shroud/radiator retaining nuts

10 On early models, unscrew and remove the upper radiator mounting nuts and washers (see illustration).

5.10a Radiator and cooling fan shroud upper mountings
5.10a Radiator and cooling fan shroud upper mountings

A Radiator mounting nut B Shroud securing screw
C Shroud securing clips
D Radiator top hose clip

Unscrew and remove the lower mounting bolts and washers and withdraw the radiator from under the vehicle (see illustration).

5.10b Lower radiator mounting bolt
5.10b Lower radiator mounting bolt

11 On all later models, the radiator is secured to the engine compartment front panel using clips and locking pegs. To release the top of the radiator, work through the cut-outs in the engine compartment front panel and remove the two radiator upper locking pegs (see illustration).

5.11Removing a radiator upper locking peg
5.11Removing a radiator upper locking peg

Working under the front of the vehicle, remove the two radiator lower mounting bolts. Support the radiator from underneath. Squeeze the upper radiator locking pegs to release them from the engine compartment front panel and lower the radiator assembly from the vehicle.

Refitting
12 Refitting is a reversal of removal, bearing in mind the following points.

13 Refill the cooling system.

14 On automatic transmission models, check and if necessary top-up the transmission fluid level.


© 2018 www.fsierra.ru. All Rights Reserved.